BOOSTING THE HOME VALUE - 7 CHEAP TIPS

Boosting The Home Value - 7 Cheap Tips

Boosting The Home Value - 7 Cheap Tips

Blog Article

The Federal Mortgage Fraud Task Force is looking for crooked mortgage brokers, dishonest real estate brokers and cheating home buyers and real estate investors. While most people play it on the straight and narrow, good deeds can be mistaken for bad. Stay out of the mortgage fraud spot light using a few simple techniques!

Regardless of its' location, if the chip is a lot bigger than 3 inches than most glass company firms will tell you that you need to replace it. If the chip is smaller than that, it can usually be fixed. The important thing is that you do not get talked into replacing your windshield when it is not necessary. If you suspect that a simple front window repair job would suffice, get at least 3-5 opinions before making the final call.



You will next see what is called a parting bead which is a small trim piece about 1/2 inch by 3/4 inch in size partially buried in the window casing. It separates the two sashes. I recommend replacing these and you will find they are very difficult to remove without splintering them. If you are repairing the window and not installing new side tracks you must replace the parting beads. The upper sash and weight removal is the same as the bottom. Don't forget to open the sash pockets at the bottom of the upper sash tracks as well to allow sash weight removals. With sash, weights, nails and pulleys removed, clean all loose paint from remaining surfaces and if your sure it is not lead paint, some sanding may be in order as well.

Check for irregularities. If you're at the windshield repair or rear of the car, look along the car to see if there are small dents. These can be seen as distortions in the reflection. If the paint is not smooth in one place, then this could be a place where there has been some damage. Dents as large as a coin can be restored by a panel beater. Dents that are not thoroughly repaired are often filled with polyester resin or fibreglass paste. Tap the surface, or go along it with a magnet. Know whether the panel is made of steel, not plastic, fibreglass or aluminum. If there are places where the magnet will not adhere, then in all likelihood, the panel has been repaired. Ask the owner why the part has been repainted?

Check with your insurance, because it's likely your insurance will pay for some forms of windshield chip repair. They may even waive the deductible, since repairing your windshield is so much cheaper than replacing a windshield. Should you need total windshield replacement, you may have to pay a deductible with your insurance.

The syringe cover is to be removed now and the syringe should be pressed with the repair compound into the support rod. Keep twisting till the syringe is in its position.

Step 7 - Remove the finishing film after a 10 minute period and make sure the resin had dried completely. Scrape away any excess resin from the surface.

Report this page